base
Introduction
base
base
device
device
Get the cap state
Get the device's config
Healthcheck
Check if the driver is running and able to serve requests
Run CIP (Clean In Place).
1.Connect the Cleaning connector to the Nozzle.
Connect
Try to connect to the physical device
Disconnect
Disconnect from the physical device
Dispense the labware in the agar dispenser.
1.Manually switch Valve-2 to the DP/CIP position, leaving the rest of the valves unchanged.
Run draining.
1.Manually switch Valve-3 to the CIP position, leaving the rest of the valves unchanged.
Run drying.
1.Manually switch Valve-1 to the Dry position, leaving the rest of the valves unchanged.
Publish initial events
Publish synthetic events to produce the current state of the system. Returns names of published events
Reset any errors on the agar dispenser
Run simple SIP.
Only used in continuous dispensing mode.
Run SIP (Sterilization In Place).
Pre-filling pipeline SIP (Sterilization In Place):